Issue 9, 2016

A one-step electrodeposition of homogeneous and vertically aligned nanotubes with parahydrophobic properties (high water adhesion)

Abstract

Here, we report for the first time parahydrophobic (high water adhesion) vertically aligned nanotubes by a one-step electropolymerization of naphtho[2,3-b]thieno[3,4-e][1,4]dioxine (NaphDOT) without surfactants and hard templates. The formation of nanotubes is probably due to the stabilization by the polymer of gas bubbles produced in situ during the electropolymerization process. The nanotubes are obtained by cyclic voltammetry or at constant potential, but their formation is highly dependent on the deposition method. From cyclic voltammetry it was found that the size of the nanotubes is extremely large ( ≈ 300 nm) and independent of the number of deposition scans, while only the density of nanotubes increases. At constant potential, all the seeds for the nanotube formation are created in the first moments, while the size of the nanotube increases with the deposition charge. Here, θw values up to 135° are obtained even if the polymer is intrinsically highly hydrophilic (Young's angle θY = 63.6°). Moreover, water droplets put on these substrates remain stuck even after an inclination of 90° revealing extremely high adhesion. Such materials could be used in water transportation and harvesting, energy systems and biosensing.

Graphical abstract: A one-step electrodeposition of homogeneous and vertically aligned nanotubes with parahydrophobic properties (high water adhesion)

Supplementary files

Article information

Article type
Communication
Submitted
16 Nov 2015
Accepted
14 Dez 2015
First published
14 Dez 2015

J. Mater. Chem. A, 2016,4, 3197-3203

A one-step electrodeposition of homogeneous and vertically aligned nanotubes with parahydrophobic properties (high water adhesion)

T. Darmanin and F. Guittard, J. Mater. Chem. A, 2016, 4, 3197 DOI: 10.1039/C5TA09253A

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements