Issue 5, 2017

Novel non-target analysis of fluorine compounds using ICPMS/MS and HPLC-ICPMS/MS

Abstract

Measuring sub-ppm levels of fluorine (F) directly with a commercial ICPMS is not possible due to the high ionisation potential of F. Mixing of barium and fluorine solutions enabled a new approach in fluorine analysis through the formation of the polyatomic ion BaF+ using ICPMS/MS. Different parameters such as reaction gas flow rate, sampling position, nebuliser and makeup gas flow rate, waiting and acquisition time as well as RF power were optimized in order to obtain the highest possible sensitivities for 138Ba19F+, as these parameters were important for polyatomic ion formation, avoiding barium oxide and barium hydroxide ion interference and sensitive detection in MS/MS. A limit of detection (LOD) of 0.043 mg L−1 was achieved with a good recovery of fluoride spiked in deionised water. For fluorine speciation analysis, coupling of anion exchange chromatography online with ICPMS/MS allowed separation and fluorine specific detection of fluoride and fluoroacetate. The response was compound independent as expected for ICPMS. The LODs of fluoride and fluoroacetate were 0.022 mg L−1 and 0.11 mg L−1, respectively. Both compounds were baseline separated and detected quantitatively, making this newly developed method a promising candidate for non-target fluorine speciation analysis in environmental samples.

Graphical abstract: Novel non-target analysis of fluorine compounds using ICPMS/MS and HPLC-ICPMS/MS

Supplementary files

Article information

Article type
Paper
Submitted
04 feb 2017
Accepted
06 apr 2017
First published
06 apr 2017

J. Anal. At. Spectrom., 2017,32, 942-950

Novel non-target analysis of fluorine compounds using ICPMS/MS and HPLC-ICPMS/MS

N. L. A. Jamari, J. F. Dohmann, A. Raab, E. M. Krupp and J. Feldmann, J. Anal. At. Spectrom., 2017, 32, 942 DOI: 10.1039/C7JA00051K

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements