Issue 4, 2019

Direct elemental analysis of petroleum heavy fractions by means of ICP-OES equipped with a high temperature torch integrated sample introduction system

Abstract

The present work describes and discusses the use of a high temperature sample introduction system, hTISIS, for the analysis of crude oil and heavy petroleum fractions by means of inductively coupled plasma optical emission spectrometry, ICP-OES. A commercially available sample introduction system based on a conventional cyclonic spray chamber operated at room temperature has been used for comparison purposes. The method has been based on gentle heating of the sample while stirring, dilution and introduction into the spectrometer. A 5 μL solution volume has been injected into an air carrier stream and introduced to the sample introduction system. Therefore, a transient signal has been obtained. Meanwhile, the quantification strategy has consisted in an external calibration using a single set of multielemental standards prepared in xylene. The achieved results indicate that, for crude oil and its heavy cuts, the hTISIS operated at 400 °C provides signal enhancements in terms of peak height of about 4 to 15 times with respect to the cyclonic spray chamber. Furthermore, the repeatability is improved and the limits of quantitation lowered when working with the high temperature device. The measured LODs for real samples have also been determined and it has been observed that the cyclonic spray chamber affords figures 2.5 to 50 times higher than the hTISIS at 400 °C. Moreover, for the latter design, matrix effects have been compensated for and it has been possible to apply the concept of universal calibration in which a single set of xylene multielemental standards has been applied to the simultaneous accurate quantification of silicon, vanadium, iron, aluminum and nickel in crude oil, atmospheric residue, fuel, vacuum residue and vacuum distillates.

Graphical abstract: Direct elemental analysis of petroleum heavy fractions by means of ICP-OES equipped with a high temperature torch integrated sample introduction system

Supplementary files

Article information

Article type
Paper
Submitted
01 okt 2018
Accepted
26 noy 2018
First published
27 noy 2018

J. Anal. At. Spectrom., 2019,34, 664-673

Direct elemental analysis of petroleum heavy fractions by means of ICP-OES equipped with a high temperature torch integrated sample introduction system

R. Sánchez, J. Lefevre and J. Todolí, J. Anal. At. Spectrom., 2019, 34, 664 DOI: 10.1039/C8JA00320C

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements