Issue 2, 2024

Low-temperature curable TiO2 sol for separator and HTM-free carbon-based perovskite solar cells

Abstract

In this study, we present the development of an ambient temperature curable TiO2 mesoporous layer for perovskite solar cells (PSCs), eliminating the need for a binder and enabling the use of environmentally friendly solvents. The TiO2 layer was synthesized via a hydrothermal method followed by minimal post-processing techniques. The resulting anatase TiO2 sol was optimized to be compatible with various coating techniques such as spin coating, dip coating, and spray coating, allowing for its application at sub-50 °C temperatures. A comprehensive investigation was conducted to study the effects of annealing temperatures ranging from 50 °C to 500 °C on the crystallographic, morphological, electrical, and surface properties of the TiO2 films derived from the TiO2 sol. Contact angle measurements were employed to analyse the change in surface energy resulting from different sintering temperatures and its influence on the growth of the perovskite film on the TiO2 films. To evaluate the performance of the TiO2 electron transport layers (ETLs) annealed at different temperatures, carbon-based perovskite solar cells (CPSCs) were fabricated. The results revealed that the CPSCs utilizing the TiO2 ETL annealed at 50 °C exhibited the highest efficiency of 11.1%, accompanied by an open circuit voltage of 0.98 V and a current density of 22.3 mA cm−2. Notably, the developed TiO2 ETL outperformed the commercial TiO2 ETL sintered at 500 °C in the same device architecture. These findings demonstrate the potential of the ambient temperature curable TiO2 ETL for large-area deposition and flexible PSCs.

Graphical abstract: Low-temperature curable TiO2 sol for separator and HTM-free carbon-based perovskite solar cells

Supplementary files

Article information

Article type
Paper
Submitted
17 iyl 2023
Accepted
25 sen 2023
First published
26 sen 2023
This article is Open Access
Creative Commons BY-NC license

Mater. Adv., 2024,5, 539-548

Low-temperature curable TiO2 sol for separator and HTM-free carbon-based perovskite solar cells

R. D. K, T. R. Elumalai, E. Ramasamy, S. Mallick, T. N. Rao and G. Veerappan, Mater. Adv., 2024, 5, 539 DOI: 10.1039/D3MA00427A

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements