Issue 12, 2020

3D-printed Cu2O photoelectrodes for photoelectrochemical water splitting

Abstract

Photoelectrochemical (PEC) water splitting is an alternative to fossil fuel combustion involving the generation of renewable hydrogen without environmental pollution or greenhouse gas emissions. Cuprous oxide (Cu2O) is a promising semiconducting material for the simple reduction of hydrogen from water, in which the conduction band edge is slightly negative compared to the water reduction potential. However, the solar-to-hydrogen conversion efficiency of Cu2O is lower than the theoretical value due to a short carrier-diffusion length under the effective light absorption depth. Thus, increasing light absorption in the electrode–electrolyte interfacial layer of a Cu2O photoelectrode can enhance PEC performance. In this study, a Cu2O 3D photoelectrode comprised of pyramid arrays was fabricated using a two-step method involving direct-ink-writing of graphene structures. This was followed by the electrodeposition of a Cu current-collecting layer and a p–n homojunction Cu2O photocatalyst layer onto the printed structures. The performance for PEC water splitting was enhanced by increasing the total light absorption area (Aa) of the photoelectrode via controlling the electrode topography. The 3D photoelectrode (Aa = 3.2 cm2) printed on the substrate area of 1.0 cm2 exhibited a photocurrent (Iph) of −3.01 mA at 0.02 V (vs. RHE), which is approximately three times higher than that of a planar photoelectrode with an Aa = 1.0 cm2 (Iph = −0.91 mA). Our 3D printing strategy provides a flexible approach for the design and the fabrication of highly efficient PEC photoelectrodes.

Graphical abstract: 3D-printed Cu2O photoelectrodes for photoelectrochemical water splitting

Supplementary files

Article information

Article type
Paper
Submitted
23 iyn 2020
Accepted
23 avq 2020
First published
07 sen 2020
This article is Open Access
Creative Commons BY-NC license

Nanoscale Adv., 2020,2, 5600-5606

3D-printed Cu2O photoelectrodes for photoelectrochemical water splitting

J. Ahn, S. Lee, J. H. Kim, M. Wajahat, H. H. Sim, J. Bae, J. Pyo, M. Jahandar, D. C. Lim and S. K. Seol, Nanoscale Adv., 2020, 2, 5600 DOI: 10.1039/D0NA00512F

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements