Issue 32, 2021

The effect of THF and the chelating modifier DTHFP on the copolymerisation of β-myrcene and styrene: kinetics, microstructures, morphologies, and mechanical properties

Abstract

The statistical anionic copolymerisation of the biobased monomer β-myrcene with styrene in cyclohexane was investigated via in situ near-infrared (NIR) spectroscopy, focusing on the influence of the modifiers (i.e., Lewis bases) tetrahydrofuran (THF) and 2,2-di(2-tetrahydrofuryl)propane (DTHFP) on the reactivity ratios. With increasing [modifier]/[Li] ratio, the reactivity ratios in the system myrcene/styrene are adjustable from rSrMyrvia rSrMyr to rSrMyr. The bidentate modifier DTHFP affects the reactivity ratios much more than THF: minute amounts only (0.35 equivalent relative to Li) are required to randomize the copolymer, and one equivalent to invert the reactivity ratios. Using these reactivity ratios, copolymer composition profiles are obtained, which upon increasing the modifier concentration vary from tapered, block-like copolymers to random to inversely tapered copolymers. 1H-NMR spectroscopy was used to determine the microstructure of the myrcene units in the copolymers. With increasing [modifier]/[Li] ratio, the content of 1,4-units decreases and the content of 3,4- and 1,2-units increases. DTHFP as a modifier minimizes the content of 1,2-units. The glass transition temperatures also depend on the [modifier]/[Li] ratio, but less strongly than in the copolymer poly(styrene-co-isoprene). Although all copolymers have the same composition (33%mol myrcene, corresponding to 39.6%weight and 45%vol), very similar molecular weights (about 90 kg mol−1) and low dispersities (1.06 to 1.10), different morphologies could be obtained. Lamellar, cylindrical and gyroid structures were identified by TEM and SAXS measurements. The mechanical properties vary in a wide range from hard and brittle to soft and flexible. The gyroid structure showed the highest Young's modulus and no viscoelastic deformation.

Graphical abstract: The effect of THF and the chelating modifier DTHFP on the copolymerisation of β-myrcene and styrene: kinetics, microstructures, morphologies, and mechanical properties

Supplementary files

Article information

Article type
Paper
Submitted
11 জুন 2021
Accepted
19 জুলাই 2021
First published
20 জুলাই 2021

Polym. Chem., 2021,12, 4632-4642

The effect of THF and the chelating modifier DTHFP on the copolymerisation of β-myrcene and styrene: kinetics, microstructures, morphologies, and mechanical properties

D. A. H. Fuchs, H. Hübner, T. Kraus, B. Niebuur, M. Gallei, H. Frey and A. H. E. Müller, Polym. Chem., 2021, 12, 4632 DOI: 10.1039/D1PY00791B

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements