Issue 32, 2017

Ti-doped α-Fe2O3 nanorods with controllable morphology by carbon layer coating for enhanced photoelectrochemical water oxidation

Abstract

Ti-doped α-Fe2O3 nanorods (NRs) with carbon layer coating were fabricated for photoelectrochemical (PEC) water oxidation. The α-Fe2O3 NRs were grown on the surface of a Ti foil substrate by hydrothermal synthesis. Ti4+ was diffused from the Ti substrate and doped into the α-Fe2O3 NRs by sintering at 800 °C. The presence of Fe2+ in the α-Fe2O3 lattice was achieved by annealing the NRs in a lack of oxygen atmosphere, e.g. in argon. The co-existence of Ti4+ and Fe2+ results in significant enhancement of the PEC performance compared with the hematite NRs obtained by annealing in air, showing the absence of Fe2+. The carbon layer coating was conducted by the carbonization of glucose. Impressively, the coated carbon layer can not only facilitate the charge transfer of the photogenerated carriers but also effectively restrain the structural aggregation of the NRs upon high temperature sintering. The carbon layer coated NRs exhibited 1.2 times higher photocurrent density than the uncoated NRs due to the reduced charge recombination and well-distinct NR structures.

Graphical abstract: Ti-doped α-Fe2O3 nanorods with controllable morphology by carbon layer coating for enhanced photoelectrochemical water oxidation

Supplementary files

Article information

Article type
Paper
Submitted
09 ማርች 2017
Accepted
18 ኤፕሪ 2017
First published
18 ኤፕሪ 2017

Dalton Trans., 2017,46, 10558-10563

Ti-doped α-Fe2O3 nanorods with controllable morphology by carbon layer coating for enhanced photoelectrochemical water oxidation

D. Yan, J. Liu, Z. Shang and H. Luo, Dalton Trans., 2017, 46, 10558 DOI: 10.1039/C7DT00850C

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements