Issue 5, 2016

Highly efficient low temperature solution processable planar type CH3NH3PbI3 perovskite flexible solar cells

Abstract

The current density–voltage (JV) hysteresis and power conversion efficiency (η) of planar type CH3NH3PbI3 perovskite solar cells with TiO2 and ZnO electron conductors, which are formed by high temperature spray pyrolysis deposition at 450 °C and by room temperature spin-coating and subsequent heat-treatment at 150 °C, respectively, were compared. The ZnO based perovskite solar cells exhibited better efficiency deviation (15.96 ± 1.07%) and less JV hysteresis than the TiO2 based cells (15.20 ± 1.23%) because the ZnO based cell has 1.2 fold longer charge carrier life time (τn) than the ZnO based cell and the ZnO electron conductor has better electron conductivity (0.0031 mS cm−1) than the TiO2 electron conductor (0.00006 mS cm−1), thereby balancing the electron flux and the hole flux more. Due to the low temperature solution processability of the ZnO electron conductor, we could demonstrate a highly efficient PEN (poly-ethylenenaphthalate)/ITO/ZnO/CH3NH3PbI3 perovskite/PTAA/Au flexible planar solar cell with 1.1 V open-circuit voltage (Voc), 18.7 short-circuit current density (mA cm−2) Jsc, 75% fill factor (FF), and 15.4% η for the forward scan direction and 1.1 V Voc, 18.7 mA cm−2Jsc, 76% FF and 15.6% η for the reverse scan direction under illumination of 1 Sun.

Graphical abstract: Highly efficient low temperature solution processable planar type CH3NH3PbI3 perovskite flexible solar cells

Supplementary files

Article information

Article type
Communication
Submitted
23 ኖቬም 2015
Accepted
04 ጃንዩ 2016
First published
04 ጃንዩ 2016

J. Mater. Chem. A, 2016,4, 1572-1578

Highly efficient low temperature solution processable planar type CH3NH3PbI3 perovskite flexible solar cells

J. H. Heo, M. H. Lee, H. J. Han, B. R. Patil, J. S. Yu and S. H. Im, J. Mater. Chem. A, 2016, 4, 1572 DOI: 10.1039/C5TA09520D

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements