Issue 1, 2018

Extraction and characterization methods for titanium dioxide nanoparticles from commercialized sunscreens

Abstract

Sunscreens are an important source of TiO2 nanoparticles in surface waters. The fate and toxicity of these particles have not been fully addressed due to the gap between model nanoparticles usually used in studies and the more complex particles found in commercial products. Therefore, mild extraction methods for TiO2 nanoparticles from sunscreens were evaluated for providing more realistic nanoparticle samples for future studies. We propose two methods based on ultrafiltration and ultracentrifugation, respectively, for extracting TiO2 nanoparticles from sunscreens using a surfactant solution as the solvent. These methods were tested on eleven commercial sunscreens with differing compositions. The ultracentrifugation variant allows extracting 250 mg from approximately 5 g of sunscreen in one day. Recoveries for ultrafiltration and ultracentrifugation were 52–96% and 78–98%, respectively. Purification efficiency was determined for the ultracentrifugation variant by determining the avobenzone concentration in sunscreen extracts using UV-spectrometry and was high for all tested sunscreens. Transmission electron microscopy and dynamic light scattering revealed a high diversity in particle shape, although size parameters were comparable (average hydrodynamic diameter: 19–34 nm). Isoelectric points were below 4.6 for all sunscreen extracts. Time-of-flight secondary ion mass spectrometry revealed that probably all TiO2 particles were coated; most of them with PDMS, some others with Al- and Si-based materials. Comparison of images of particles inside the sunscreens using cryogenic transmission electron microscopy and of extracted particles showed that while the shape of the primary nanoparticles was not affected by the extraction, they were agglomerated inside the sunscreens. These agglomerates could be completely disrupted using ultrasonication. Therefore, the particles extracted in the present study can be considered as more environmentally relevant in terms of size, shape, surface charge and coating than model TiO2 nanoparticles.

Graphical abstract: Extraction and characterization methods for titanium dioxide nanoparticles from commercialized sunscreens

Supplementary files

Article information

Article type
Paper
Submitted
25 Jul 2017
Accepted
29 Nov 2017
First published
30 Nov 2017

Environ. Sci.: Nano, 2018,5, 191-202

Extraction and characterization methods for titanium dioxide nanoparticles from commercialized sunscreens

A. Philippe, J. Košík, A. Welle, J. Guigner, O. Clemens and G. E. Schaumann, Environ. Sci.: Nano, 2018, 5, 191 DOI: 10.1039/C7EN00677B

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements