Issue 18, 1992

Oxidation of Fe(CN) 4–6 by S2O 2–8 in AOT–oil–water microemulsions

Abstract

The Oxidation of hexacyanoferrat (II) by peroxodisulfate has been studied in sodium bis(2-ethylhexyl) sulfosuccinate (aerosol-OT or AOT)–oil–water microemulsions at 298.2 K. The rate of this reaction is appreciably higher in a microemulsion than when it takes place in a conventional aqueous solution. The dependence of the rate constants on the surfactant concentration, on the nature of the oil phase and on the molar ratio w=[H2O]/[AOT] has been investigated. Results show that when the AOT concentration remains constant, the reaction rate increases by decreasing the molar ratio, w. For a given [H2O]/[AOT] value, the reaction rate shows no dependence on the surfactant concentration or on the nature of the oil phase.

Article information

Article type
Paper

J. Chem. Soc., Faraday Trans., 1992,88, 2701-2704

Oxidation of Fe(CN)4–6 by S2O2–8 in AOT–oil–water microemulsions

P. López, A. Rodríguez, C. Gómez-Herrera, F. Sánchez and M. L. Moyá, J. Chem. Soc., Faraday Trans., 1992, 88, 2701 DOI: 10.1039/FT9928802701

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Spotlight

Advertisements