Issue 39, 2011

Formation of relief structures on fibres by photo-embossing

Abstract

Relief structures are created on the surface of fibres to generate new effects in these fibres. More specifically, photo-embossing is used to generate the relief structures and to generate a non-contact process without etching procedures which could eventually be applied in high-speed and continuous spinning lines. Typically, a photopolymer mixture consisting of a polymeric binder, a monomer and a photo-initiator is directly spun into a monofilament fibre. The rheological properties of the photopolymer mixture are measured, and it is shown that the photopolymer mixture is visco-elastic at elevated temperatures. Fibres are prepared from the photopolymer mixture, and surface relief structures are generated perpendicular to the fibre axis by photo-embossing using a mask exposure. Optical microscopy (OM) and scanning electron microscopy (SEM) are employed to study the surface morphology of the fibres. It is shown that the height of the surface relief structures is strongly dependent on the pitch of the line mask and on the diameter of the fibres. At optimized conditions, patterned fibres are produced with well-defined surface relief structures. The fibres are rather brittle which is related to the crosslinked chemical network in the fibres.

Graphical abstract: Formation of relief structures on fibres by photo-embossing

Article information

Article type
Paper
Submitted
26 May 2011
Accepted
01 Aug 2011
First published
25 Aug 2011

J. Mater. Chem., 2011,21, 15527-15531

Formation of relief structures on fibres by photo-embossing

M. Dai, O. T. Picot, N. F. Hughes-Brittain, T. Peijs and C. W. M. Bastiaansen, J. Mater. Chem., 2011, 21, 15527 DOI: 10.1039/C1JM12365C

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Spotlight

Advertisements